you would like some assistance in selecting a
product or ordering an
item, then simply
contact us here at
Hypro EU by calling us on 01954 260097 or e-mailing
Technical advice is freely available from
experts. To enable them
to select the right nozzle
to optimise your spray
application, it would be
helpful if you can provide
the following information.
Essential information required:
- The application
(a brief description) including the liquid being sprayed
rate required (L/min // L/h // or Other)
- Pressure available
(psi; Bar or Other)
- Spray pattern required (Flat, cone,
- Preferred pipe connection (Male, Female)
- Nozzle distance
from target (specify units)
iinformation about your application::
- Liquid temp
- Liquid viscosity at temperature
- Specific gravity or density
- Surface tension
- Any solids present in liquid?
- Spray impact (High, Medium, Low)
- Droplet size (Coarse, Medium,
- Preferred nozzle material
- Desired nozzle spacing
To place an order or for general information please contact us
on 01954 260097 or e-mail to
All orders are subject to Hypro’s
conditions of sale.
Orders accepted after 3 pm (Mon-Thurs) or 2 pm (Fri) will be
processed on the next working day
Deliveries to the UK mainland with an
order value over £50
are carriage paid (3-4 day service). Quicker delivery and carriage
to other destinations can be quoted
Orders below £50.00 will attract a £15.00 carriage, packing and administration charge and will be delivered
on a next weekday service.
Goods should be inspected immediately on receipt and any issues
reported in writing within 10 days. Goods should only be returned
with prior agreement from Hypro.
Hypro operate an internal
quality management system which draws on over 55 years of
experience in manufacturing spray nozzles and the standards
expected by our many and varied customers. Where customers have
specific quality assurance requirements these should be stated at
the time of order.
Flow rate information
given for spray nozzles is based on the performance obtained using
clean water at a temperature of 13-18°C. Flow rates are intended
as an approximate guide to the performance that may be expected.
Variations will occur, particularly with liquids of varying
viscosity and specific gravity. These variations can be advised by
customer service department.
Hypro’s policy is one of
continuous development. We reserve the right to change designs and
without prior notice. This means that the Illustrations and tables
shown in this publication are for guidance only and
part numbers may be
superseded or become obsolete.
Hypro bears no responsibility for the way
in which the information given may be used.